Kit Packing C5 Vette PAC controller ____ Pump w/4 Feet shielded cable ____ 4 Feet 7/16 split loom ____ 2 lon
8) Final At this point you’ve concluded the installation, first thing to do is before putting alcohol/water into the tank, is turn the ignition “on
Individual results may vary, enjoy the product. 10) Interference On some types of scan-tools it may be possible the PWM signal to drive the pump c
PAC- Progressive Alcohol Controller Introduction The PAC is a versatile electronic motor controller using pulse width modulation technology
can be routed from a relay activated by the ignition switch. Black goes to chassis ground. The connections to the injection pump are the Red/Black/Whi
pump as the signal from the MAP sensor increases. Turning this knob clockwise will increase output voltage multiplication and slightly increase the in
setting in main controller. Once this is done, monitoring engine knock, race car…. If knock retard is encountered, ascertain if the knock is occurri
Alky Pump install Important notes… Do Not Mount pump with head facing upwards as this will allow water to collect inside sleeve and ruin motor. Pleas
C5 Corvette installation instructions 1) The tank modification The windshield washer tank will need to be modified to deliver the fluid to th
2) Pump mounting Before mounting the pump, install the brass 90 degree fitting on the inlet of the pump, use the larger of the two fittings provided
3) Nozzle The nozzle will be placed before throttle body. Install head of nozzle in the upper portion of the air bridge 2 o’clock position on Mag
the MAP sensor. At this point remove the lower panel under the dash, and the panel that goes under the steering column. Drill holes and run LED wir
2)Razor blade 3)Heat gun or lighter Step 1 Strip insulation from end of pump cable and separate wires. Note there are three wires. Red, Black, ba
Step 3 Apply heat to the heat-shrink. Step4 Slide large heat-shrink over entire connections Step 5 In the event more than one wire will be at
Mount PAC controller in aluminum frame, it will need to be loosened to fit in place. Reinstall frame. Then ZIP tie the controller in place through
Comments to this Manuals